SOP: Resolve and close a work order

The record that makes every report useful.

Learning Track · Module 10: SOPs · Step 86 of 101

1. Select the cause from the list. Use “other” only if no cause fits.
2. Record each part used.
3. Add a photo of the finished work.
4. Raise a new job for any follow-up work.
5. Resolve the job.
6. The supervisor checks the record and photo, then closes it or returns it.

Note

A job without a cause is a lost lesson. Repeat-failure and warranty reports depend on this step.

Sources

1. EN 50110-1 Operation of electrical installations
2. OSHA 29 CFR 1910.147 Control of hazardous energy (lockout/tagout)
3. CEA (Measures relating to Safety and Electric Supply) Regulations

Changes: 30 October 2026: First publication: guides for Europe, the Middle East, South Asia, and the USA; failure library; tender clause library; comparisons; tools; downloads. See the changelog. Found a mistake? Report it.

Mark completeOpen in the Learning Track

PreviousSOP: Commission a controller or nodeNext module: Standards by regionStandards and rules in Europe